Aquamist users........

atc82

New member
i use everything the aquamist systems does, except for the pump. I use 2 7mm jets with the aquamist tubing and a big shurflow pump.

Turn on point is set at 10 psi. This is with 50lb injectors, TE-61 with 3" dp, and an ATR upper. I really think that I could use the larger jets, and it helps if you can pull the fueling out in the chip.

that is with methanol btw.

I say bigger jets. Your truck is modded correct?
 

atc82

New member
I say put the 1mm jets in it with those mods. I think that is the biggest you can get from Aquamist. Where are you injecting it at? Throttle body? Maybe the pump could be causing the spark retard when it comes on??
 

4C FED

Absolutum Dominium
Pump is mounted under the pass. headlight.
Mixture goes in about 6-8" above that.

I want to adjust the turn on point down to ~5-8 psi.

I don't have my directions, which way do I turn the adjusting screw to lower the turn on point?
 

Falco

Donating Member
I'm using 2x1 mm jets in the TB. 50/50% water/methanol. 10 psi turn on point. No knocks at 18 psi. BTW I used to adjust the turn on point with a Mityvac vacuum pump. Just hook up a boost gauge if you have the older type (which measures only vacuum) and disconnect the line to the jets and point it to the windshield or back to the reservoir. Ignition on and start to create pressure slowly with the pump...

HTH,
 

It's just a six

Super Member
Re: Aquamist users........

I am using two .4 mm jets & was wondering if it would be OK to run .5 or even bigger on my "stock" Sy.
I seem to be having some knock retard.
Is there a point of using too big a jets where it seem to slow down?
Any ideas on what size jets I should buy?
Does anyone here have any they would want to sell?
Thanks all !!!
 

leroy

Donating Member
Re: Aquamist users........

You can drill out your .4mm jets to whatever size you want. Look for a #drill to metric conversion, then use or buy the appropriate bit.

Jim
 

It's just a six

Super Member
Re: Aquamist users........

Thanks, so you are saying to just drill them out?
Mikuni jets are drilled & flow tested ,are Aquamist jets flow tested. It's posible by just drilling them I could reduce flow?
Just something to think about.
 
Last edited:
Top