ATR headers & RPM down pipe not fitting.

1madgumby

New member
Have RPM Downpipe for A PTE 72 turbo, ATR headers & the WG pipe coming off the down pipe is hitting the header tube. Anyone know A fix to this. it is about 1/8 to 1/4 off. from being lined up. Don't want to beat the hell out of the pipe.

Aj.
 

sy#2921

BAMF
Re: ATR headers & RPM down pipe not fitting.

Maybe some pics would help some of the guys. I have experienced a problem with the DP and the #6 tube on my ATR header/PTE downpipe combo but I just have to make sure the DP is rotated correct. From your description its the WG pipe hitting the #2 tube though
 

Icarus-54

Donating Old Member
Re: ATR headers & RPM down pipe not fitting.

I had the same problem,#2 pipe hiting the wg pipe.First I installed the wg and then took a ballpeen hammer and dented in the tube at the joint of the 2 wg tubes.Then tapped a small flat on the #2 tube of the header,problem solved.You must install the wg because once you peen the tubes(wg) you can't move them.
Jack
 

1madgumby

New member
Re: ATR headers & RPM down pipe not fitting.

Just put the WG on last night & will be doing that here in A few. what did you do for A intake tube for the turbo? It is right aginist the Rad. (almost).

Aj.
 

Ry368

one mile = 5280 feet
Re: ATR headers & RPM down pipe not fitting.

sy1219 said:
Just put the WG on last night & will be doing that here in A few. what did you do for A intake tube for the turbo? It is right aginist the Rad. (almost).

Aj.
If it's only 1/8 -1/4" ....i'd prolly heat it up a little with my torch and give it a little dimple!
 

1madgumby

New member
Re: ATR headers & RPM down pipe not fitting.

I really did not want to beat on it, just got it back from getting cermaic coating.

Aj.
 

NecroWolf

lost marbles member
Re: ATR headers & RPM down pipe not fitting.

it didn't hurt mine to uh, dimple them slicghtly. the coating scratched a little but if you used a rubber hammer or padded the tip it shouldn't leave a mark
 

ghettosled

SYTY SUPERSTORE
Re: ATR headers & RPM down pipe not fitting.

fyi, in the future you can also install a T3 inlet flange (b/t the turbo/headers) as a spacer to move the turbo out just enough to clear.
 
Top