Bad bin question

TYTILIDIE

METH HEAD
Looks I had a bin go bad. Im not sure how this happens but it sucks to say the least. Bad news is that I did not have a copy of it. Is there any way to retrieve the good standing tune?
 

Quickstop [UK]

Combating adversyty.
Re: Bad bin question

Were you logging it? Is it not in Tuner Pro? Did you email it? If you updated the bin from TP and didn't shut down TP then you should still jar it but I guess you know that.

Bummer :(
 

WyoSyclone

Active member
Re: Bad bin question

Looks I had a bin go bad. Im not sure how this happens but it sucks to say the least. Bad news is that I did not have a copy of it. Is there any way to retrieve the good standing tune?

I've had that happen a time or two.... always seems to be during a battery disconnect/reconnect cycle. Lots of KR is usually the first giveaway that something is not right. Hope you can retrieve it!
 

TYTILIDIE

METH HEAD
Re: Bad bin question

Here is what happened. As usual, the temp changes outside and leaves me to adjust the temp table. So I took it with me to a friends house. While I was waiting in front of his house, I made some minor changes while monitoring but I was not logging. The tune did not respond to the changes so I siad screw it and put it away. Well, when I went to leave, the truck would start but was in limp home mode. So I reloaded the bin and it ran ok. I left the laptop on and logged the way home on DM. After that, it just plain didn't work anymore.

I tried over and over to reload the bin with no result. I turned the key on and tried to connect with DM but it was like I had no chip in there. So I loaded my older bin and the truck fires up but runs not so great. It ran okay enough to drive but was pretty rich. At the gas station I tried to reload the other bin (my normal one) and the truck stalled in the middle of the parking lot. I had to load the other bin back in to get back home. And for some reason, Tuner Pro is causing my computer to crash and it crashed itself when I try to copy and paste a table. I tried re-downloading it but it doesn't get any better.

I'm not sure what to do about this, looks like I may have to start over.
 

WyoSyclone

Active member
Re: Bad bin question

I would suspect a ribbon cable before anything else... start with the simple things first. If you have a chip, burn the BIN onto a chip and try that.
 

TYTILIDIE

METH HEAD
Re: Bad bin question

I would suspect a ribbon cable before anything else... start with the simple things first. If you have a chip, burn the BIN onto a chip and try that.

I actually tried that. It was one of the first things I tried. I did some digging and found the bin, I just had to pull it off an old flash drive. I'll have to make a few changes but it wasn't long so I remember what they were. Truck still runs like crap. Looks like I have a a fouled #6 so I am going to replace the plugs tomorrow and see what happens.
 

TYTILIDIE

METH HEAD
Re: Bad bin question

You could try a Windows restore.

Jim

Funny you mention that. When I said I was stalled in the parking lot, I actually had to leave the truck there for about an hour because when the laptop crashed, it said it needed to repair itself and could take an hour. I let it do its thing and when I went back that is how I was able to get it going again.

Fingers crossed for fouled plugs.
 
Top