Bad Chip? Spark Retard Issues

Goshinki

New member
Installed 9n1 chip... and truck is not running correctly on any setting.

Before installing it the truck was running great. No spark retard. Only thing that I could complain about would be a poor idle when cold. (Tested with DM 2 months earlier.)

Here is my crapy Data Master run from today.
http://d01.megashares.com/dl/f9479c4/rawr1.rar


Truck is running on about 1/8 the power it feels like.

When turning on Valet mode on my chip my car is unable to start.



Also when in park and reving the engine I get a little spark retard...

All seemed fine before the install... bad chip? bad luck?

Redid spark plugs, wires and rotor about 3 months ago.



Going to put back in the stock chip and test it again tomorrow.



Any ideas until then?


This was the chip I bought.

http://www.syty.net/forums/showthread.php?t=70245&highlight=todd+chip








==================================================================
Update Edit

Just put my stock chip in and truck is running fine. Minus my poor idle before the truck warms up.

Did a little boost launch to 0-60 and didn't get any Spark Retard.

Here is my run in DM with the stock chip.
http://d01.megashares.com/dl/5c68070/rawr4.uni
 
Last edited:

SY-1193

Active member
Re: Bad Chip? Spark Retard Issues

Goshinki,
If that is your actual chip pictured in that first picture in the link you put up that is a UV erasable chip.
A UV erasable chip is erased when exposed to a UV bulb (quick method) but can also be affected eventually by sunlight if that little round window is not covered up by a sticker or piece of tape to shield it from UV rays. If it sat long enough in sunlight it will eventually corrupt the chip. Was the round window covered up on your chip? If not you will need to have it reprogrammed most likely. Your truck is probably running on the failsafe part of the original chip when you piggyback it on the new chip resulting in the loss of power/performance...it is in limp home mode. My guess anyway...
 

Goshinki

New member
Re: Bad Chip? Spark Retard Issues

It was never in the sunlight while in my hands.

Was in a box in my nice cool house.

Even during the quick install it was in the box until I put it in.
 

SY-1193

Active member
Re: Bad Chip? Spark Retard Issues

If you have Datamaster on you can switch the chips settings with your multichip switch and see the PROM ID changing in the upper right hand corner of Datamaster if you are Monitoring or Recording. Have you tried reseating the chip/carrier in the computer? Do you have the correct chip for your injector size?
 
Last edited:

jpalmer

New member
Re: Bad Chip? Spark Retard Issues

sorry i have not posted sooner, pos internet was not working. I sold him the chip, it was never in any uv and it ran in my truck on my initial start up. But if there is a problem with it i can refund your money. sorry for any inconvenience. i dont know what could have happened to it. damaged in shipping?

Just let me know how i can help if needed. i know almost nothing about the chip other than it ran in my truck, and it was all stock. Maybe something else is amiss but i dont know how to fix it.

let me know what you wanna do.
 
Top