cat-vi
Ty Wannabe
I got the BigStuff3 ECM with SyTy harness from Precision Turbo, anybody familiar with this setup? If anybody could clear out this for me it would be highly appreciated. I find it a bit strange that the wire from the knock sensor connected to original ECM Connector C311 at circuit F9 is not connected to the BigStuff3 ECM through the SyTy harness.
1. Which Circuit at the BS3 ECM do I connect the knock sensor? Since this is a turbo-charged engine it is quite critical that this function is working properly.
2. At BS3 ECM Circuit Y3 and P3, is this to be grounded? Anywhere?
3. BS3 ECM Circuit E3, what is this for? I can not find this at the drawing GEN3 PRO SEFI – MWH found at their website for downloading.
1. Which Circuit at the BS3 ECM do I connect the knock sensor? Since this is a turbo-charged engine it is quite critical that this function is working properly.
2. At BS3 ECM Circuit Y3 and P3, is this to be grounded? Anywhere?
3. BS3 ECM Circuit E3, what is this for? I can not find this at the drawing GEN3 PRO SEFI – MWH found at their website for downloading.