BLM and Integrator

JoeLutz

New member
BG Help please. My BLM stays at 138 and the integrator stays at a constant 128 all the time, operating in closed loop and the O2 sensor does appear to be working. Shouldn't at least the Integrator change some? Got the STG chip set at T1-17. My ign. voltage is kinda low (12.5-13v), I'm going to check that out as soon as it stops raining.
Thanks
 

jwaller

Evil Genius/SyTy Guru
your blm is on the high side just a bit try uping the FP by 3 lbs and see what that does....are your eng temps coming up....that could cause the BLM and INT not to update..but if it's staying at 128 and not moving thats a good thing
 

smeagol

Active member
If your integrator is 128, then it is probably in open loop, and not updating. See if the truck is warmed up, and that you are seeing 02 readings changing. Also, if you are in PE mode (when you hammer it), the integrator will set to 128.

Brian G
 

JoeLutz

New member
Brian you are right I was at WOT. I just did a short 0-60 run, hit the start button and nailed it. It must have a second delay before it starts recording. I did notice that when I let off right before I hit the stop button, the BLM did drop to like 124 for a split second. The integrator stayed at 128. The engine temp was at 176-177 and IAT was at 106 F.

John, it does feel like its running lean. I had already bumped up the FP from 50 to 53 base. I hate to just keep turning it up to cover up for another problem.
Going to try to track down the voltage drop today and make some more runs.

Thanks guys for the info and help!
 
Top