BLM going higher when I raise the FP?

dgoodhue

BuSTeD 4.3
On my truck when I raise my FP, my BLM's go higher in normal driving (my mods are ultimate and drop in K&N). To me this doesn't make sense, higher BLM mean that the ECM is adding fuel because the motor is running lean. My truck runs like crap if the BLM reach 150) If I lower the FP my truck run great at part throttle but at WOT the o2 volts are low and the truck has knock retard. I am currently runnig 46-47psi but any higher my truck runs like crap at part throttle.

I know my FP pressure goes up (I have a fuel pressure guage that will reach my windshield, but I can't read specific numbers. (It reaches ~15+ base Fp at WOT) My truck also has a crappy idle (I can see the tach waver and everyone once and a while it jumps up or down 100-150 rpm.
 

dgoodhue

BuSTeD 4.3
smeagol said:
What other mods? What is the status of your ignition? What are the coolant temps?

The only other mods I have is a Walbro, 3/4" flexible IC line, & Jabasco IC pump. ATR Wires and CR42ts plugs replaced 2000 miles ago, cap rotor replaced 1500 miles ago. The fresh ignition components didn't help idle at all. The last time I looked on my Diacom the coolant temps were around 180-195. MAT temps are usually 110.
 

smeagol

Active member
BLM shouldn't reach 150.. that seems really outta wack.

What numbers did you see before and after the fuel pressure modification?

FWIW, there are only 2 BLM values in the Syty ecm, closed throttle BLM and open throttle BLM. Nearly worthless IMO.
 

dgoodhue

BuSTeD 4.3
smeagol said:
BLM shouldn't reach 150.. that seems really outta wack.

What numbers did you see before and after the fuel pressure modification?

FWIW, there are only 2 BLM values in the Syty ecm, closed throttle BLM and open throttle BLM. Nearly worthless IMO.

I really don't remember my FP numbers, when I bought the truck 8 months ago, I went through the truck in the first 2 weeks and did all the reliability mods. (vacuum lines, fluids, filters, pumps, tune up, AFPR)

The 2 BLM values make sense, I see around 128 at closed throttle (foot off the gas and idle) and 150 when driving around normally. I thought it was odd my BLM look 'digital'. I was sort of thinking maybe I have a faulty FPR, but it does seems to rise with boost.
 

dgoodhue

BuSTeD 4.3
I verified my fuel pressure regulator was working today. I put a FP guage on the fuel line. I used a boost/vacuum guage T'ed with a Mittivac and AFPR while the engine was running (I plugged the FP vaccum line). The boost went up 1 psi with every pound boost (mittivac) and went down 1 psi for every inch of hg. (there no flats spots or anything)

The only thing I did notice was the higher the FP, the fuel pressure guage flickered more. For instance at 36psi the guage read rock steady, at 60 psi the guage flicker +/- 1psi.

I just recently added some Xylene, I read that it will clean the injectors. My truck sure likes it at WOT. So far (50 miles of driving), part throttle nothing is changed :(
 
Top