Is the F71 scale in Programmer the only factor that controls the wastegate? Here is my problem. I had custom chipping done last year and my boost control was rock solid. Over the winter I had the dozen or so cracks in my ATR headers repaired (crappy welding from ATR). Now I have severe overboost. Can I just adjust the percent of the WGDC in Programmer to correct this problem? I assume if 100% is closed, then say 0% would be open all the time? My values are about 60% now. How much does a percentage change make? Should I try 20 or 40%? I have a 20G with a ported wastegate and a Hahn high boost actuator if that helps. TIA
Darrin
Darrin