Break-in vs. Tuning

Aeroking

e.i.
When i initially fire my engine up, i need to hold the rpms at about 2500 for awhile to set the rings. It'll be starting on the 60# base tune for Code 59. and i'll datalog the whole thing.


So....million dollar question. Should i worry about adjusting the tune while holding the throttle, or just hold it at 2500rpms for 15 minutes and worry about tweaking later?
 

WyoSyclone

Active member
Re: Break-in vs. Tuning

I wouldn't attempt any tuning unless it was running pig rich - don't want to wash the cylinder walls down. Watch the AFRs and if it's way rich turn it off and bring the BPC down a bit till you get it in a range where you're not dumping too much fuel. Once you get the rings set you'll have to make sure the engine is up to operating temp before you do any tuning.
 

4C FED

Absolutum Dominium
Re: Break-in vs. Tuning

You don't need to hold it at 2500 rpms to seat the rings. If you had a flat tappet cam that would be the normal break-in procedure.
Start it up, set timing, watch for leaks, watch oil pressure & let it reach operating temp.
Turn it off, drain oil, change filter, start it up & go for an easy drive.
 

gkrcr882

SyTyless......for now!
Re: Break-in vs. Tuning

You should always start tuning at idle, then 1500, 2000, 2500, etc. Datalog under load as much as possible as well, and (obviously) start it rich.
 

TYTILIDIE

METH HEAD
Re: Break-in vs. Tuning

Break-ins are over rated IMO. Did on my first motor then built my second with a guy who used to build race motors and explained to me why it doesn't make shit of a difference. Haven't done it since and have never had an issue. I can't say I would get in there and romp on it. I usually drive normal around the block, make sure nothing leaks and then beat it up. As far as tuning goes, I wouldn't do any until you verify your valve lash is set right, there are no leaks, blah blah blah and that everything is working right. But like Rob said, if its far off you can just adjust the BPC until you are where you need to be.
 

JSM

Active member
Re: Break-in vs. Tuning

Yea, not sure the purpose of break-in on a roller cam motor. I have always been told rings break in from on/off throttle stuff not just a steady state rpm.

I will let them idle a bit high at first to make sure the oil is flowing, but after than just treat it careful until the tune is good, everything is in check.
 
Top