If you just need someone to put them in a truck and see if it will run/data log I can do that. I'm out of inspection so I can't road-test but I could certainly make sure that it will start and run OK on your ECMs..
I will have to use my PROM & Chip as I'm running a V8 so I wouldn't be able to test your PROMs..
I could also help ya out. I'm outside Dallas and mine is currently setting in the floor while I procrastinate changing out the heater core..
yes, same address will werk.
all i have is a snap on scanner but i can see percentages and stuff. before, the cel would flash on then immediately off. would always throw the code 42. replaced ignition module and rewired from ignition mod to ecm.
tach jumps when cranking but never looked at it through my scanner.