check engine light

gt71ss

Member
have a problem with timing. pull the wire on pass side to set at 0. plug back in and no differance in timing. after some searching on the site, the culpurt would be the distributor module. hate to buy parts on i think so's. any thing i'm missing? GT
 

Loeryder

New member
Re: check engine light

After you set the timing with the tan wire disconnected you have to pull the ECMB fuse to clear any codes set by not having it hooked up.
 

MRKING

New Parts for Old Trucks
Re: check engine light

I dont have the directions handy , but there is a way to test the module with a multimeter .
 

gt71ss

Member
Re: check engine light

disconnected the pos batt cable for a min. to reset. still the same. on a side note... there's a brown wire with the same type connector that's near the ecm. any thoughts where that goes? GT
 

SCWolverine

New member
Re: check engine light

MRKING said:
I dont have the directions handy , but there is a way to test the module with a multimeter .

This? http://www.asashop.org/autoinc/may97/techtips.htm

gt71ss said:
hate to buy parts on i think so's. any thing i'm missing? GT

I hear ya on that, but it wouldn't hurt in this case. Dunno how much ($30-$40?), but I've heard (read) about some replacing it with every/every other full tune up, couldn't hurt to have an extra.
 

gt71ss

Member
Re: check engine light

that's some deep electrical testing in a small area by the firewall.. not interested in pulling the distributor to check so i think your correct in the just replace it attitude. GT
 
Top