http://www.thirdgen.org/newdesign/tech/promintro.shtml
Things you'll NEED:
- An eraser (not the one on your pencil :wink: )
- A programmer (the Pocket Programmer is nice)
- Some eproms (27C128 for stock & 27C2001/27C020 for Ultimate)
- An editor (Promgrammer, Tunercat, etc....)
- Countless hours reading old posts
Things you'll WANT:
- WBO2
- Datamaster
- Erasable Eproms (nullifies purchase of eraser as well)
As far as how "hard" it is....it's not really all that hard. Almost all of the legwork has been done for our ECM, so it's just a matter of reading and figuring it out for yourself. Several things can make it easier on you (some of which I have listed), but the biggest piece of advice I can give is to read and figure it out the way that you understand. Plenty of us can tell you to "set PE AFR to X, set PE spark advance to X, etc....", but you won't benefit from that in the end. Kinda like the trigonometry homework you copied off "the smart girl" and never really learned for yourself....well, you don't wanna do that here. Only hurts in the long run.....
Hope this sheds some light,
Michael