chip question

denny

Active member
Re: chip question

Then you will need something like a 50lb injectors and chip (3 bar), 75lb would be even better.
Stock injectors can only get you so far and if you are a newbie at tuning, it ain't gonna to get you anywhere.
 

JSM

Active member
Re: chip question

all stock truck won't be mid 11's with just a chip change.
 

denny

Active member
Re: chip question

JS Manufacturing said:
all stock truck won't be mid 11's with just a chip change.

correct but its a start in the right direction.

need4speed , maybe you should rephrase your question, like what mod you'll need to get your truck in the mid 11's.
If you want to know what chip, you will need at least a 50lb chip.
 

SBNova

New member
Re: chip question

... and 50 Lb chip is not the name of a store bought chip, its the base calibration of a chip designed to use 50lb injectors. You will need to further tune it to attain your goal. Ditto with the 3 bar, which is designed to use a 3 bar map sensor.
 

need4speed

On the never ending quest
Re: chip question

Im some what new but not stupid i know ill need more then a chip to go 11's what i want to know is .........................

If 11's are my goal what set up is the "best" to incorporate mods to go 11's ?

As far as store bought im a former lightining owner and as far as a chip all i had to do was buy a blank diablo chip and get it flashed to do what i wanted it to with that chit i could change shift points, firmnes, speed density out put, fuel press, and some other stuff basically "plug and play" is their something simalar to my syclone like this ??? IF NOT WHATS THE FIRST STEP IN MY QUEST TO DO ELECTRONIC UPGRADES FOR MY TRUCK ? remember i want low to mid 11's to get their "chiping" what do I need ?

Hope that sets everything right :tup:
 

Flyin Ryan

hated cuz he drives fords
Re: chip question

well while reading Denny's above post I noticed his signature which shows he's gone mid 11's with 50lb injectors and a chip programed for the 50's so I'd figure some 50lb or 65lb injectors and either go with the Phil Long chip from turbotime or go custom tune which would prob yield a little more
 

alwayscode390

pppssssshhhhhtttttttttttt
Re: chip question

WOW, that setup is nice from Detroit Turbo....but your 3 bar map says it requires the use of a 3 bar chip....then you just reflash the chip?!

You cant just install a 3 bar map and expect to run over 15lbs on a turbo right?! ---
 

kwick6

Donating Member
Re: chip question

alwayscode390 said:
WOW, that setup is nice from Detroit Turbo....but your 3 bar map says it requires the use of a 3 bar chip....then you just reflash the chip?!

Yes, a 3 bar bin is needed. All you need is someone to email you a 3 bar starter bin to work with that resembles your build. If you change injectors, you'll need to start with a bin calibrated for those injectors. Then its a matter of using the tuning equipment, and tunerpro to dial in your setup.

You cant just install a 3 bar map and expect to run over 15lbs on a turbo right?! ---
Correct, to run over 15 psi you need the 3 bar map.


Also sent you a PM.
 
Top