chipping tables

E-Rue

New member
if im trying to smooth out the transition in fueling from vacume to boost. its unclear to me where i should be making changes.

if i make changes baseed on boost alone, i would modify the lowest entry in the F77 table. the problem is that if i modify the first entry, which is where i need some adjustment, i will in turn affect the entire fuel curve while doing anything in vacuum.

if i make a change to the upper term of the F29 table the fueling under boost will be indirectly affected.

when i look at my fueling curve, i see the ratio go nice and lean as the MAP term begins to increase, (helps with spoolup) and as soon as it approaches 0 vacume and low boost, it goes stoopid rich. there is a difference of 15.5 to 10.9 in just a few frames. its unclear to me what tables i should be modifying to achieve a smoother fueling curve, as all the options seem like they affect too many other parts of the curve.

also, approximately how many frames behind is the WB reading? or is it dead on the money?

e
 

Buster

New member
I think what your experiencing is heavy PE fuel, I leaned it out under 2400 RPMs, but above that your loaded up, look at table 61, you'll see what I'm talking about. PE fuel in enabled at 89 KPA, which is very close to 0 psi.
 

jwaller

Evil Genius/SyTy Guru
are you in AE? could be if your getting into it quickly. if not try to modify the 100kpa line in F29.
 

E-Rue

New member
cool! yes that helps, i see some of where that dramatic change in fueling is coming from now. although i still dont see exactly where i should be making changes to affect that quick transition from lean to rich. its bound to be KILLING spoolup running that rich at that low of boost.

this AE fueling isnt quite as straigh forward as the VE fueling :(

i swear the problem seems to be in the resolution of the f77 table, due to the 3bar code change. if this was a 2 bar chip i would know exactly where to make changes.

e
 

Buster

New member
E

You might need to lean out the whole PE table some to make a smooth transition, then add back in the VE table at 100 kpa as needed. I've recently made some very good head way using the romulator, the trucks out here are smooth as silk.

PM me if your having any other weird issues with that chip, I've got a few drivability things worked out, especially idle. Plus you need to edit table 77, back in the day I had that one really wacked out, especially at 15-18 psi..
 

E-Rue

New member
well you were exactly right, after i looked a few things up, the quick transition to rich was right at the PE enable caused by KPEMAP2 being set too low. i changed it from 84 to 117 which will keep it leaner during spoolup, while allowing me to shave off the big dip in the AFR curve. ill let ya know how it turns out tomorrow :wink:

if this works the way i think it does, then the change should help spoolup on any truck running a big turbo. (including yours)

e
 
Top