Clear 3/4" hose for IC lines

Phoon30

New member
Where are you guys getting this clear hose from? Can it be found at Home Depot, or is it specific for automotive applications(Pep Boys, RS Strauss, etc...)?
 

Zac

New member
My local ace hardware had the clear hose. It was listed as dishwasher/ washing machine hose.

Zac
 

GM TURBO

Sell Out
Personally, I think the clear hose is kinda nasty looking - but nobody asked.

It might be kinda cool to be able to see the coolant flow - but it is hard to Armor All a clear hose.

Also, I don't know how well the hose will stand up to the heat that is found in the engine compartment. Is it working well for others???

You can find bulk 3/4 inch heater hose at any Pep Boys. I found pre-packaged stuff - but it was only 6 ft sections - I didn't want to risk it - it prolly would have worked though.
 

Phoon30

New member
GM TURBO said:
Personally, I think the clear hose is kinda nasty looking - but nobody asked.

It might be kinda cool to be able to see the coolant flow - but it is hard to Armor All a clear hose.

Also, I don't know how well the hose will stand up to the heat that is found in the engine compartment. Is it working well for others???

You can find bulk 3/4 inch heater hose at any Pep Boys. I found pre-packaged stuff - but it was only 6 ft sections - I didn't want to risk it - it prolly would have worked though.

Yeah, it might not look as clean as the regular black hose, but it's cool to just look at the hose to see coolant flow/air bubbles rather then have to take the cap off the ic. (I'm a lazy bastard) Also, I think I remember reading a while back that the clear hose is a little stiffer, making it harder to kink the line.

I wonder how it holds up to under hood temps. That leads me to my next post. Stay tuned to the Tech forum. And thanks for the quick responses.
 

JSM

Active member
I have the NASTY clear hose.

did it for sight.

when warm, it bends/kinks easily. Cold it is fairly stiff.

I planned to cover it with insulation at some point anyways...

Maybe I can do it, when I replace the heater core that blew up on Will's foot in chicago...
 

GAShan

Donating Member
I have had one small length of clear washing machine hose in my truck since early '94. No problems. I didn't do it all that way, just the piece from the ATR pump on the fender well to the driver side of the aux heat exchanger. it's the shortest run of hose I have and I can check flow just by popping the hood and looking down between the grill and the ac condenser.
 
Top