code 42

Well I was going home friday and the truck stumbled and set code 42. First time for that. Now it seem like it is unlocking the converter going down the freeway. You can watch the tach and it will go up when it stumbles. From what I read on Sportmachine I need to replace the hei module in the dis right?
Thanks
 

ItsMyTy

Life is beter at 25 PSI
check your prom and make sure it's fully seated.

if the prom isn't in the ecm quite right it will set a 42
 
I put the pitbull and 2 bar sensor back in tuesday and hasent stumbled of set any codes. So today I put the ultimate and 3 bar sensor back in to see will know more tomarrow
 

ItsMyTy

Life is beter at 25 PSI
good

that code 42 can have you running in circles sometimes if you don't check the prom
 
Well the code 42 hasent come back yet. but the stumble is :-? I will go through and check all the grounds But I dont think thats it. Doesnt do it with the pitbull. And yes I did change the fp and map sensor when installing the ultimate.
 
Ok, did some dm runs and this is what I see


With the stock chip or the pit bull in without piggybacking them and 2 bar map. It does'nt do the stumble or the code 42.

With the stock chip or the pitbull piggybacked to the ultimate and 3bar map installed I get the stumble and the code 42.

Something that I have noticed is that when it does this the voltage drops to 12.8 then goes back up. Also the sterm will go from 90-100 to 128 in one frame. and also the knock count will go to 0.

If it was the ecm it would do it with the stock or pitbull chip.
 
Top