Code 43? (searched already)

Tophatjimmy

Syclone FNG
well, my Sy has been sitting since November. I decided to go fire it up and let it run for a few minutes last night after work. I started it up and it was idling a little rough, but not real bad, then the CHECK ENGINE light came on. Datamaster said it was a code 43 - something to do with the electronic spark timing??

In the 2 years I've had the truck it's never thrown a code, could this just be cause it's cold out and it's been sitting for almost 2 months? What can cause a code 43?

Cap, rotor (Borg Warner), wires (Autolite Premium) and plugs (Autolite) are almost 2 years old, but it idles and runs just fine...haven't had any problematic misfiring. Cleaned and gapped the plugs to .028 just before I parked it. All the plugs looked very normal.
 

bezerk

New member
Re: Code 43? (searched already)

your knock sensor is prolly broken, try to change it, and reset your ECM, by pulling the ECM A and B fuses for a while
 
Top