code 43?

KGB Pilot125

New member
You need to replace your knock sensor most likely. just to make sure run through all the tests in the manual. could be the ecm could be the wire but most likely its the sensor. they are like 18 bucks or something, make sure you get the one for the "Z" engine
 

Sy769

Donating Member
Yep I agree Some will remember me last year at the NATs changing every f'ing thing on the truck last year to get rid of it Funny thing was it passed all the tests in the service manual. If you are in doubt replace it first cheap and might save you some aggravation.
 

KGB Pilot125

New member
yes its easy

about 30 to 45 minutes

take off coil

loosen wiper motor so it moves up and down

go have a beer

get flashlight start looking for it its down under the cap and rotor kinda towards the passengers side. you should be able to feel it it has a funny little connector on it and one wire coming out of it. get the connector off its kinda a pain to do.

unscrew the sensor with proper sized socket, you will need a few swivels and extensions if I remember right, put in new one and torque down to specs.....hold on checking manual........14 foot lbs.

put it all back together. oh and disconnect the battery too before you start.

also if you have a scan tool make sure it detects knock by banging on the intake with a handle of a screwdriver or a hammer on the alternator bracket

drink rest of beer and bandage hands up from all the cuts you are gonna get. oh and make sure you dont leave your dads 20 dollar snap on screw driver down there that you will find 8 months later :grin:
 
Top