Code 51 - prom error

Wes

Donating Member
CODE 51
PROM ERROR
(FAULTY OR INCORRECT PROM)
4.3L TURBO (VIN Z) SYCLONE AND TYPHOON (PORT)

Circuit Description:
Check that all pins are fully inserted in the socket and that PROM is properly seated. If OK, replace PROM, clear memory, and recheck. If Code 51 reappears, REPLACE ECM.




Having some trouble here http://www.syty.net/phpBB2/viewtopic.php?t=38847&start=15
In just one frame of our latest datamaster file, this 51 code came up.

I don't think there's anything wrong with the connections, although we haven't checked the chip. It is a fairly recent burn of the Ultimate 50# chip. Could there be something wrong with the chip? Or could it be that the ECM is going bad?

We were having trouble before with the old chip, the truck would die for a split second, not much knock though. It also had some hesitation when you would step on the gas. We then went to the more recent burn and the hesitation went away, and it was running pretty good. Now it's having problems again.
 

gmcturbo

Active member
check that at the same time you didnt get a data error. when i get one my KR jumps way up or i get a whacko fault code. if that data err came up in the same frame i would disregard it.
 

PPI Typhoon

DIY Madman
If you need, I have a reader if you need to check and see if the chip is good or not.

If you need, give me a call. 480-232-0989
 

Wes

Donating Member
OK we may have to take you up on that. We're gonna have to make sure everything is contacting good, and if it's still having the problem i guess checking the chip would be the next step.

PPI Typhoon said:
If you need, I have a reader if you need to check and see if the chip is good or not.

If you need, give me a call. 480-232-0989
 

Wes

Donating Member
kreepstr said:
check that at the same time you didnt get a data error. when i get one my KR jumps way up or i get a whacko fault code. if that data err came up in the same frame i would disregard it.

I think it did get a data error on the same frame, but just going off the problems I described Dig said it sounds like the chip could be loose. But a chip fits in pretty good and has no pressure on it, so the only thing I can think of is maybe one of the prongs got bent in when I installed it and is barely contacting. Either that, or the chip is bad, or the chip hardware (ultimate black box or circuit board) is bad, or the ECM is bad. We'll just have to eliminate the potential candidates as problems 1 at a time.
 
Top