Commander 950 engine management system...?

HotRudyRod

New member
I was reading Holley's catalog and found this product http://www.holley.com/products.asp?product=950-110 it has a lot of tunning potential i read and lots of interesting features and it can also be upgraded to do a lot more things.

My question is if it would let me raise the boost levels as easy as the Ultimate or i would have to buy a boost control to do so? Anyone has tried it yet?

Too bad the site doesnt explain the features as well as the catalog does.

Thanks.
 

2kwik4u

Resident slow guy
Re: Commander 950 engine management system...?

You would want at least the 950pro, as I think the regular 950 only handles 1-bar map sensor (Mainifold Absolute Pressure - 1bar=just vacuum).....

The stock PCM has more control IMO than any of the Holley products have, however with that extra power/control there is a GINORMOUS learning curve (think trying to walk up mt everest in your underwear, and your getting close).

With that said, Raising boost takes more than just a chip/PCM mod. You need to have th rest of the basics done (FP, AFPR, plugs/cap/rotor - Read the FAQ's).
 

HotRudyRod

New member
Re: Commander 950 engine management system...?

Thanks for your input 2kwik, i already have all the basic mods like the Warlboro 255, billet FPR, 3 bar, Julios PAC, 20G, NOS IC spray bar, a bunch of gauges (air/fuel, vac/boost and tach/shift light), and soon a Waller tranny and a 9/11 2,800rpm TC.
With all those add ons i think im goin to need some upgrades on the ignition and computer systems to keep tabs on everything and also a way to tune everything up, i already have the datamaster but i would like to tune fuel and ignition curves from the cockpit and at the race track, im a distributor for Holley Peformance and would like to use as many parts from their catalog as possible. Any sugestions???

Thanks again.
 

2kwik4u

Resident slow guy
Re: Commander 950 engine management system...?

OK after reading here, I have a better handle on the truck/situation.....disregard about 1/2 of my PM :D

The 950Pro that I have used was a good setup, and it worked well for the most part.

The software DID NOT like windows XP AT ALL.....Had to go to a Windows2000 laptop before it would work well. The datalogging works well, and all ofthe tables are VERY striaghtforward. It has wideband input, and lots of other features. I'm not sure how well the knock control works, as the particular truck I was working on didn't use that feature (yes I fussed at the owner about it).....

The truck was initially setup with a regular commander 950, and once upgraded to the 950pro firmware, and made aware of boost, it worked even better. He's running high 12's with that truck, and I think about 8-10psi of boost. However it's a supercharged 1g S10. Close, but not the same......

If you are set on using the holley, it will work OK I think. I don't think it's for everyone, after seeing some trucks in teh mid 12's with stock ultimate chips, I would have a hard time jsutifying the cost personally.
 

HotRudyRod

New member
Re: Commander 950 engine management system...?

Thanks again Mike. I'll stay with the stock unit 'till i get a better notion on how the ECM works.
 
Last edited:
Top