condeming an ecm

Status
Not open for further replies.

MR_MNZTR_SY

New member
before i do anything stupid, i was just curious about what everyone thought.

heres my situation: i cannot build boost over 7-10 psi. the computer is reading my boost levels way beyond this (like 15-19) and blowing the wastegate early. the MAP sensor checks out as being good. the wastegate solenoid functions properly, the relays are good. i do not get an overboost code.

im out of things to check and the conclusion i have come to is basically, a bad ecm. they arent too expensive, but obviously i just want to be sure.
 

smeagol

Active member
What scan tool are you using?

Can you run 10-12psi base boost by unplugging the wastegate solenoid? How have you determined the solenoid works properly?

If I questioned any expensive part, I'd try finding someone local to try a *KNOWN GOOD* part; ECM especially.

Doesn't cost you $ to test this.

EDIT

locking this thread, already have one going in Tech forum or something for the same problems.

Isn't a tuning issue, it's a tech/repair issue anyhoo.
 
Status
Not open for further replies.
Top