Considering L35 swap

MoJo

New member
Re: Considering L35 swap

You could bolt the L35 heads on you motor, use stock rockers, stock push rods and net-lash adjustment nuts and not have any problems..... if you have a stock camshaft. .The addition of a high lift camshaft creates a new set of problems.
 
Last edited:

Couger1968

Dazed and Confused
Re: Considering L35 swap

Here is my plan for my heads ,since I am running a stockish cam. I plan on putting ARP 100-7201 studs in , SEALED POWER Part # R973 Rocker Arm Assembly and COMP Cams 4604-16 Rocker Arm Adjusting Nuts. That should be about $140 I think that would be the cheapest way to go. The COMP Cams 1417-12 Magnum Steel Roller Tip Rocker Arms would come with nuts, but they look like prevailing nuts and might cause trouble with the ARP studs. I guess ARP studs are a class 3 thread and have very tight tolerances and when adjusted there is a lot of friction and almost seizes it on the stud and the factory studs are class 2 and the nut fits looser around the thread and will let you move it more. I was reading comps website (http://www.compcams.com/Pages/412/general-motors-technical-info.aspx) about push rod guide holes and they said that after 1988 they switched to a self aligning system and that although there may be an alignment guide on the head, it is not hardened and is used only to align the pushrod during assembly. Do I still need to enlarge it for a factory type set up?
 

MoJo

New member
Re: Considering L35 swap

That will probably work unless the ARP 100-7201 rocker studs are too short for the Comp Cams 4604 poly-locks. If they are too short, you can always use the prevailing torque nuts that come in the kit.

I assume that Comp Cams may be correct about the "push rod guide" holes in the heads but it sounds fishy to me. The push rod holes in my "064" L35 heads are perfectly round and are .400" in diameter for a .313" push rod which may be plenty of clearance. We reamed out those holes to .438" anyway in order to avoid any possibility of binding of the push rod. The push rod hole in the heads may not be in perfect alignment between the push rod seat in the rocker arm and the push rod seat in the lifter. The 7/16" reamer eliminated all doubt. Reaming or elongating the push rod holes is absolutely necessary if 1.6:1 rocker arms are to be used because those rockers move the push rod .060" closer to the rocker stud. Remember that if you ever want to add 1.6:1 rocker arms..

BTW.....ARP rocker studs have Class 3 threads. That is why they recommend using poly-locks on their studs. Most automotive threads are Class 2 threads and will put stress on the stud. . The prevailing torque adjustment nuts are really hard on Class 3 threads. Use those type nuts on ARP studs several times and the threads on the stud will be sharp as razors.
 
Last edited:
Top