Cranking a/f ratio

leroy

Donating Member
The f54 table designated a cranking a/f ratio. Since I'm running 55# injectors, I don't need as much pulsewidth for cranking. Should I raise the a/f ratios in the table to achieve this?

The f56, cold engine a/f ratio is similar.

I think I made some adjustments for cold engine when I was working on a 50# injector chip.

Any experience in this area? Brian?

Jim
 

smeagol

Active member
I never had the 55s installed long enough to deal with fine tuning drivability.

The answer is probably ;)

To answer this, let's assume your calibration, your old injectors, and your new 55# injectors are all ideal, both sets of injectors are perfect. If this was the case, you wouldn't have to rescale the AFR values, since you have already accounted for the larger injector flowrate in the F28 BPC value, and the injector pulsewidth would be scaled across the board from this change.

This ideal situation is obviously not the case, so you may have to fine tune and tweak those tables with the new injectors. Now you have to determine if you change it in the injector linearity tables or the startup fueling tables.

What I would do is see how it starts up now. If ok, start tuning the VE table for idle/drivability. See how that affects startup... if you needed a lower VE for idling, you may affect the startup fueling. Might have to scale with coolant temp to change for hot startup etc.
 

leroy

Donating Member
It's not clear in the P4 document that the f28 table is a factor in determining the cold a/f ratio, but that makes the most sense. I haven't studied the hack enough to figure it out.

When I first put the injectors in, the truck started better than it ever had. It still starts well, but I don't want to throw any extra fuel in there if it's not needed.

Driveability is getting really good, still don't have the wot stuff exactly right, and fighting mechanical problems also.

Thanks again Brian.

Jim
 

kwick6

Donating Member
Please keep us posted on your progress with them. Are you tuning with a wideband 02?

Later,
Scott
 

leroy

Donating Member
Yes, I'm using a wideband. I have a pretty good base for someone else to work from if they have 55# injectors. There are so many variations with truck modifications, that some programming would still be needed. For example, my truck has a cam, ported stock heads, PTE63, water injection, and burns oil :( . I doubt if anyone else has that setup. :wink:

Jim
 
Top