Datamaster boost does not equal boost gauge?

psmvchaser

Member
If I compare my boost on my pillar gauge to the boost on the datamaster, it is always 2-3 lbs more on the gauge than datamaster says.

Anyone else have this problem? I'm guessing that datamaster would be correct? Why would it be off?

I have a 2 1/16 autometer boost guage which is run off of the manifold port (I bought the one that screws directly into the manifold and has the post for the boost gauge line.

Ken Germain
 

TYTILIDIE

METH HEAD
Re: Datamaster boost does not equal boost gauge?

Do you ahve a 3bar MAP? If so, did you convert DM to that setting?
 

SBNova

New member
Re: Datamaster boost does not equal boost gauge?

So how far off is it? I would guess that MAP's are not exactly calibrated, which is where your ECM gets the reading to send to DM. I had an Autometer volt meter that was off by 1 full volt, so dont think they cant be faulted either.
 

JB's Red Ty

Still Green
Re: Datamaster boost does not equal boost gauge?

funny, I just noticed my Subie has the opposite issue....I have the same gauge as you and my piggyback computer reads 2-3 psi higher.

Still better than my last gauge that read at 1/2 the actual boost...nasty email to Autometer on that one. This is my third gauge in 1 year from them.
 

psmvchaser

Member
Re: Datamaster boost does not equal boost gauge?

Interesting. I just wish I knew which one was right. It's about 2-3 lbs lower on datamaster then on the guage.
 
Top