Datamaster File Reading

willyson

trollin'
dm071320061.jpg


A few questions concerning datamaster. My peak boost target pressure is around 9.5-10. I know I have a boost leak somewhere near the turbo, but shouldn't this target be near 15ish if my wastegate solenoid is working? I think I am also running lean.
My Turbo WGDC (wastegate dump count??) is nearly continuous100. If someone can post the actual DM File for me that would be great.

Any thoughts/suggestions? Anything else look bad? DTC Error is code 43, but dont know how to get it to stop flagging every once in a while.

Thanks
Mark
 
Last edited:

SBNova

New member
Re: Datamaster File Reading

Just a few things that seemed off to me here, and I am not used to reading datamaster (why isnt the info at the bottom matching the info at the top??). Anyway, your O2 mv is .920, which may be slightly lean (shouldnt really use a NB to read rich/lean at WOT, thats why I say "may"). You have 4.6 degrees of KR noted at the top, thats too much. You are either lean, dont have good gas, have too much spark advance, or your IAT's are too high. Your IAT is 48.7 which is about 118 degrees, so that doesnt look to be the problem. As for the desired boost psi not matching the actual, is may be because the ecm reduces boost when knock retard exceeds a certain amount. WGDC is wastegate duty cycle.
 

ircwet

New member
Re: Datamaster File Reading

I reset my ecm and got ride of my code 43 and after I did a tune up I havent seen it since....
 

willyson

trollin'
Re: Datamaster File Reading

SBNova said:
Just a few things that seemed off to me here, and I am not used to reading datamaster (why isnt the info at the bottom matching the info at the top??). Anyway, your O2 mv is .920, which may be slightly lean (shouldnt really use a NB to read rich/lean at WOT, thats why I say "may"). You have 4.6 degrees of KR noted at the top, thats too much. You are either lean, dont have good gas, have too much spark advance, or your IAT's are too high. Your IAT is 48.7 which is about 118 degrees, so that doesnt look to be the problem. As for the desired boost psi not matching the actual, is may be because the ecm reduces boost when knock retard exceeds a certain amount. WGDC is wastegate duty cycle.

im not sure why it isnt matching unless i selected a point on the graph and this is that specific info for that frame. Being lean, I dont have an AFPR, which is not helping. What do you mean by NB? Is there any way to tell if the WG solenoid is functioning thru DM? I have changed solenoids and still dont know if its functioning. I'm thinking the wire off of the solenoid is cut/sliced somewhere under the TB.
 

Tooky

Serious about performance
Re: Datamaster File Reading

If your turbo WasteGateDutyCycle is at 100% under WOT then your boost leak near your turbo must be pretty damn big!!!!!! Get that fixed before you waste any more time trying to diagnose anything. That's a HUGE problem.
 

JSM

Active member
Re: Datamaster File Reading

100% WGDC = ECM is commanding as much boost as possible

0% WGDC = ECM is bleeding off as much as possible

A lot of people get confused.

Looks like you have a few issues. AFPR, boost leak, knock, ....
 
Top