datamaster files need help
- Thread starter rman2424
- Start date
Re: datamaster files need help
I just had a code 35 myself. I pulled the IAC valve, tested it and cleaned it. Make sure you soak a piece of cloth in carb cleaner and stuff it in the IAC hole and spin it. Repeat till it comes out clean. Plug the IAC back onto the harness and key on and watch the pintle move. Re install it and pull your ECM fuses to reset the computer. My idle quality improved dramatically and my wideband quit hunting all over the place.
I just had a code 35 myself. I pulled the IAC valve, tested it and cleaned it. Make sure you soak a piece of cloth in carb cleaner and stuff it in the IAC hole and spin it. Repeat till it comes out clean. Plug the IAC back onto the harness and key on and watch the pintle move. Re install it and pull your ECM fuses to reset the computer. My idle quality improved dramatically and my wideband quit hunting all over the place.
rman2424
Donating Member
Re: datamaster files need help
hey thanks for help alrready put new one in and today pullled pcm out of my other truck no change bad hesiation wont drive in gear on load or just acelerating dies let it idle awile it just dies when it sarts it idles way high almost 2500 then slowly comes down.has bog at about 1000 rpm
hey thanks for help alrready put new one in and today pullled pcm out of my other truck no change bad hesiation wont drive in gear on load or just acelerating dies let it idle awile it just dies when it sarts it idles way high almost 2500 then slowly comes down.has bog at about 1000 rpm