TurboManiacal
Donating Member
Hey All,
Pulled out the Datamaster that I had bought (Personal Reasons don't ask) and tried linking my computer to the Syclone.
I quickly found out the cable that came directly from TTS physically links from my laptop to the ALDL port on the truck. There is one serial connector that is un-used...now will it fit/connect between Cable & Laptop.
I physically connected the cable & started Datamaster and the truck started freaking out w/ erratic idle and blinking Check Engine light. There was no PCM sync between Datamaster and the ECM.
I physically disconnected Datamaster and the truck returned to normal.
Later this weekend I went up to NL and tried hooking to Rene's truck with my Laptop. Same results. I then swapped my Official Datamaster Cable with his "home made" cable. Laptop immediately synced up and began recording fine.
Thoughts? Suggestions?
Pulled out the Datamaster that I had bought (Personal Reasons don't ask) and tried linking my computer to the Syclone.
I quickly found out the cable that came directly from TTS physically links from my laptop to the ALDL port on the truck. There is one serial connector that is un-used...now will it fit/connect between Cable & Laptop.
I physically connected the cable & started Datamaster and the truck started freaking out w/ erratic idle and blinking Check Engine light. There was no PCM sync between Datamaster and the ECM.
I physically disconnected Datamaster and the truck returned to normal.
Later this weekend I went up to NL and tried hooking to Rene's truck with my Laptop. Same results. I then swapped my Official Datamaster Cable with his "home made" cable. Laptop immediately synced up and began recording fine.
Thoughts? Suggestions?