Datamaster with #50 <=feedback?

bezerk

New member
To bad i have a datamaster wich i haven''t had the change to learn about it becasue of..........

but a friend of mine has installed his walbro, 3bar map sensor, #50 injectors and his ultimate.

The problem he has is that with the #50 Ultimate the engine beganns to stumple at 4000RPM, with his otherchip wich isn''t made for #50 it''s alot better.

when we ran the Ultimate it has an much to high knock-count and ofcourse its knock retard.

annybody is willing to read this 2 runs???
 

Spencer

New member
Which setting are you using with the Ultimate? .

You might need to add more fuel until the knock goes away. Try a richer setting on the ultimate and/or raise the base fuel pressure.
 

bezerk

New member
we have tried T1-15 T1-20 .

about changing base feulpressure, it could be, but why is it that on the other chip (1 program of the ultimate, don''t know wich) the knock doesn''t accure, it even isn''t a #50 chip.

if it was my car i could try to play with the tuning, but this guy doesn''t life close.
 

Spencer

New member
You might want to recommend the guy get an updated version of the 50# programs. The newer version is setup differently with two different timing settings that each have 7 different fuel settings (only in boost). T1-F1 leanest to T1-F7 richest.


I can't tell you why the knock is occurring on the 50 chip and not the other. They are not the exact same chip so it may not give you the same results.


For starters set the base static (no vacuum) fuel pressure to around 45 psi. If the knock is still there increase 1/4 - 1/2 turn and try again. Keep on increasing base fuel pressure by a 1/4 - 1/2 until knock is reduced or eliminated.

That might work.
 

InvisiBill

Active member
Each injector flows differently at different amounts, i.e. a 50# injector isn't always putting out exactly twice as much as a 25# injector. But in general, a 50# would be about twice as much as a 25#.

The stock injectors are 33#. That means a 50# injector is putting out about 50% more fuel than a stocker. If you're using a stock chip, the 50# injector would be spraying a lot more fuel than a stock injector.

My somewhat clueless guess is that the it's running lean. The non-50# chip is causing the 50# injectors to dump a lot of extra fuel into the engine, making up for being lean, and getting rid of the knock.
 

bezerk

New member
Sigo, i will sent the files to your e-mail adress, okay?

Sorry that i couldn''t make it, had a meeting in Belgium (not SyTy related). and we have a Show next week with the company, so alot of work.

So good luck building, and give me the results!

And what are we going to do with the $$$$$$$$$$$$?
 
Top