datamaster ?

spooldup

Super Member
I was reading the help section but could not find an answer to this. Ok when you drive the trucks the graph on the bottom goes to the right until that graph is full but it continues. My question is how do you look at it when you playback? I can only look a the original graph that was there so when it goes past it i can't see it.
 

Rufus

New member
During data collection, the graph is in 'scrolling' and shows the last 100 records (max).

When you are collecting data you must be in recording (not monitor) mode AND the green Record ON button must be activated.

If what is happening is that you only see the last 100 records or so on playback, you probably had the recording off (indicated by the RED "Recording OFF" status message), and when you exit is will only save the last 100 records -

HTH

Gary
 

Rufus

New member
Guess I don't quite understand what the problem is - When you playback the file, everything that was recorded is shown on the graph by default. How much data did you think you recorded vs what are you actually seeing?

Gary
 

SeattleSy#1255

Category 5 Conservative
I think what he is trying to say is that...it records, then when he is done recording, and plays back the entire file, he can only see what was first recorded (the original first tracks that appeared on the graph) but everything past that he can't see...

Perhaps you are in some sort of zoom mode? Try clicking around on the graph and to the right of it with both mouse buttons?

I don't know what to tell ya???
 

spooldup

Super Member
ok i guess i suck at describing this problem. I will try it this way. You know that graph at the bottom is only so big so when the data reaches the end of it it continues on another graph. My problem is i can't see the other graph. Basically i drove the car longer than one graph and i want to see whats on the other one but when i move the cursor all the way to right it stops.
 

Tooky

Serious about performance
Just close the Serial Data Acquisition window and it will by default, open up your file and show you the entire contents. Otherwise start dataMaster and do a File-Playback Datafile.
 
Top