DIY-WB Parts source

BillC

New member
I'm building a TechEdge WB O2 sensor kit, and I'm looking for the connector that the O2 sensor plugs into. Honda wants to sell me a complete $1100 engine harness (they apparently don't sell replacement plugs). None of the junkyards around here are willing to cut one off the wiring harness of any of their wrecks.

Does anyone know where to buy the plug? I need part number(s) and contact info (name, phone number, etc.).

TIA
 
B

Blake

Guest
Bruce gave a link to a place that sold them. I'll see if I can find it.
http://www.sws.co.jp/stb_e/FRM/FILE/11FILE/11.htm
There's the link. Look at specifications. I haven't contacted them. So I don't know who carries their products. Bruce was one of the main guys on this but I don't know if he cares to associate with us anymore after some of the less than mature of our bunch alienated him :mad:
If anyone can talk to him maybe he can help.
I know he mentioned these same connectors were used in other places on the same car. One of his examples was the the plugs for the headlights. Maybe the junk yards would give up one or two of those.
George
 

leroy

Donating Member
Bill,

I just cut the connector off. I pulled the resistor out of the connector and soldered it to the board. That way you only have to run 5 wires to the sensor. Just remember you will have to replace the resistor when you replace the O2 sensor.

Did that make sense?

Jim
 

leroy

Donating Member
Bill,

If you decide to go with the Honda connector, George is right. The Sumitomo connector was used in different places on a lot of models, as I understand it. Look at 90-95 Hondas. Especially headlight, distributor and O2 sensor connectors.

There is also a group purchase for the connectors someone is sponsoring, with a 20 piece minimum. Additional crimpers/tools may be needed.

On a related note, I went to the local Motorola radio shop and asked for some 7 conductor cable. They gave me 15 feet for free! This works well to run from the board to the sensor. You can add a couple of weatherpack or metripack connectors for convenience.

Jim
 

BillC

New member
I stopped at a junkyard yesterday, and picked up a couple of plugs. As you said, Jim, there is a matching plug in the headlight circuit. However, there only appears to be one of these headlights circuit plugs per car (the engines had been removed in all the cars I looked at with this style plugs, so I couldn't check the distributor or O2 sensor circuits).

If anyone else goes to the junkyard, there is one minor catch: the wiring is wrong in the plug -- the headlight circuit plug has 5 pins, whereas the O2 sensor has 7. To solve this, I simply grabbed another plug (6 pins) from which to swipe pins.
 
Top