Does anyone else have this problem?

spooldup

Super Member
On the datamaster i am getting 85.8 as the pulse width. I know i am overworking the injectors but according to atr i should not have any problems. The following mods are done to the ty. ATR 850cfm turbo, ATR custom dp, ATR Pitbull, ATR wastgate, ATR aux intercooler, ATR cold air kit, ATR exhaust, Walker 3" cat, shurflo, AFPR, and that about wraps it up. Anyway according to atr they said that with the turbo i have there is no reason to upgrade the injectors. Well according to datamaster i have to. Anyone else with this problem?
 

jwaller

Evil Genius/SyTy Guru
well according to many runs I have seen...stock injectors frequently go over 100%...so I wouldnt worry
 

smeagol

Active member
Ain't nothing you can do about it. That value is set in the calibration, not learned based on your modifications.

Stock & most aftermarket cals will run high duty cycles.

I'd rather see lower duty cycle, which is why I went to the 50# setup.
 

JoeLutz

New member
Why do you sometimes see the Inj DC jump well over 100% ? Is that just noise? When its at 100% the injectors are running static, right? TIA
 

kwick6

Donating Member
I thought the inj pulse width should look something like this.

60/RPM...
So at 4000rpm, 60/4000=.015 or 15ms PW
3500rpm, 60/3500=.017 or 17ms PW

Anything over 15ms @ 4000 rpm you have ran out of injector.
And anything over 17ms @ 3500 your out of inj.

Say you see you have a PW of 12ms at 4000rpm, so 12ms/15ms=.8 or 80% duty cycle.

Is this correct? Why would he see a PW of 85.8? I thought that the PW was set in the calibration and the duty cycle was calculated by the scan tool?

TIA,
Scott
 
Top