Does the 50# Ultimate require a separate boost controller?

mrweelr

New member
I'm about to buy the 50# ultimate chip, 50# injectors, PTE52 kit, A2A, and a ton of other stuff. What I need to know is, does the ultimate/3-bar control boost using the PTE wastegate or do I need an electronic boost controller? Can the two work together to control boost? I'm considering the HKS EVC IV unit but if I don't need it then I'll save the money. Anyone?
 

CLONE

New member
Since it's a beta chip it may or may not control it perfectly. On my truck is was damn close though. A few tweaks and it was perfect. I'd save your money and use the ultimate.
 

mrweelr

New member
What do you mean by "not perfect."? Are you getting boost spikes? What kind of tweaks did you make? I'd rather not spend $500 on an electronic boost controller if I don't need it.
 

smeagol

Active member
Here's what I recommend, not knowing your plans or goals.

Use the chip, try the boost control I have built in (it is built in and there, just not perfected yet - this is referring to the 50# Beta programs). Tune and make changes, see how it works out. If no good, use the base boost setting and adjust the rod to your liking. Base boost should be 15psi. If you are going lower with the base boost there is a problem, as the wastegate is not sealing and exhaust is leaking by it. You need to run at least 15psi base boost with that actuator, period.

Later versions will have better boost control and other features/fixes/upgrades.
 

mrweelr

New member
OK Brian, I'll try the chip without the boost controller and take it from there. I do have a couple of questions. Where can I get the most updated Ultimate 50# chip along with the injectors? Also, will you provide PROM updates for free or do I have to buy a whole new chip when you make changes?
 

smeagol

Active member
I've only been selling one beta chip setup for the 50s on stock motors. I have sold several versions of 50# programs for buildups with heads/cam etc. Mike at AR is selling them, Jerry McCoy sells them as well.

Updates cost $30 from me. Mainly to cover shipping, eprom costs (since I usually don't see the original one), and my time. If any arrangements can be made to eliminate shipping, as in at gatherings/nationals, and I can trade eproms and get the original back, I'd do it for next to nothing.

Also, some people aren't comfortable swapping the eprom out (and I don't blame them, it's easy to bend the pins) and send me the whole assembly, for me to swap 'em.
 

mrweelr

New member
Thanks BG, that answers my questions. I'll be putting my order in within the next few weeks :D
 
Top