dyno tuning

PJ2397SY

Donating Member
has anyone had any experience w removing the front shaft and getting on a dyno? is there any effect on the tranny/trans case? would there be to much strain on the v coupling?
any help or advice would be great.
thanks
pj
 

JSM

Active member
Re: dyno tuning

It has been done several times, and a lot of times it is the only way.

I have personally found it doesn't simulate very well on a turbo vehicle, as you are going from a 60mph roll, boost doesn't act the same, overboost, underboost, etc.

I prefer NOT to do any tuning on a dyno, as the vehicles I tend to tune are street driven and not dyno queens.

I would like to try a true load dyno though, instead of the roller type. One that can actually load the motor at a steady rpm.

Jeff
 

dgoodhue

BuSTeD 4.3
Re: dyno tuning

PJ2397SY said:
has anyone had any experience w removing the front shaft and getting on a dyno? is there any effect on the tranny/trans case? would there be to much strain on the v coupling?
any help or advice would be great.
thanks
pj

PJ have you figure out the spark retard issue yet?
 

PJ2397SY

Donating Member
Re: dyno tuning

no but i think its possible that the rear intake gasket may have something to do w it?
i have the intake off and im polishing the inside of the plenum and intake myself. dont know if its going to be a help but it makes me feel better its done. i also have the injectors being bench flo tested and matched and the fp reg being checked out maybe a faulty diaphram.
 
Top