ealge H-beams

Syonara

New member
whats the max hp for eagle h-beams??

if i have je pistons and a steel crank(w/4bolt).......the rods(eagles) are the weak point?

600hp? more?
 

93TyGuy

Boost Freak
Re: ealge H-beams

From what i have seen the eagle H-beams are good for about 600 horsepower. Any more I would probly go for Manley H-beams or something comparable or go ballz out with carillo or oliver rods.
 

0260IN3

Engine Builder
Re: ealge H-beams

Depending on RPM and stroke of the engine the HP capabilities of the rods are different.


A 3.48 stroke (stock) with the RPM under 6000, the eagles are good for about 800 crank horsepower (maybe a lttle more). The same rods for a small block chev, Eagle rates for 750 HP @ 7000rpm.
 

GarnetTy1473

Donating Member
Re: ealge H-beams

It's not sy or ty, but this is whats left to an Eagle H beam rod out of our Camaro, seen in my sig. Not sure exactly what happened because everything was destroyed.

Engine-parts-010.jpg

Engine-parts-004.jpg

Engine-parts-007.jpg
 

SeattleSy#1255

Category 5 Conservative
Re: ealge H-beams

Syonara said:
whats the max hp for eagle h-beams??

if i have je pistons and a steel crank(w/4bolt).......the rods(eagles) are the weak point?

600hp? more?

I have wondered this too....if you go with JE pistons, treated crank, and then something like Oliver.........seems the crank is now the weak spot? only other option is what, a billet one for 2500...there is no inbetween it seems.
 

qbnkiller

Conflaguration Specialist
Re: ealge H-beams

...was that on a nitrous motor? Those rods had something extreme happen to them to cause that kind of damage.
 
Re: ealge H-beams

with the exception of a few sy/ty owners we will never have to worry about the eagle rods, treated crank, spr or je pistons failing. there's probably only a dozen people on here pushing the stock blocks to the max. the only thing that is going to kill those parts mentioned is detonation. owners that have not properly tuned their trucks , and beating the piss out of the all the time. it's not the parts that fail but the owners of the trucks. look at what phil long and ed hess did with stock blocks. properly tuned, well maintained trucks will last forever. just my :2cents:
 

GarnetTy1473

Donating Member
Re: ealge H-beams

qbnkiller said:
...was that on a nitrous motor? Those rods had something extreme happen to them to cause that kind of damage.

Nope, all motor. Car weighs about 2650lbs, and have had it down to 9.07 in the 1/4. Never put it on a dyno though, so I don't know what kind of power it's pushing.
 
Top