Electric Water temp gauge help!

Gbodydriver

Member
I have a autometer pro-comp ultra-lite 4337. Thats the electric water temp gauge. My question is :

Can it be wired without the supplied sending units?

If not where do I install them at?
 

BoostedSUV

Active member
Re: Electric Water temp gauge help!

You need the sending unit. Have to screw it into a water jacket on the intake manifold. There should be a spot around or on the water neck
 

Gbodydriver

Member
Re: Electric Water temp gauge help!

Im lost on this one.. So I just screw it in? No drilling or anything?

Anyone have a pic?
 

SY2932

Administrator
Re: Electric Water temp gauge help!

Im lost on this one.. So I just screw it in? No drilling or anything?

Anyone have a pic?

If things were so easy on these trucks, everyone would have one :lol:. Nope get out your trusty "R" drill and 1/8" X 27 NPT tap and go at it. If you don't have a letter drill, you can use a 11/32" in place of an "R" drill. An "R" drill is .339" and a 11/32" drill is .34375"... There are some pics in this thread of an install.
 

BoostedSUV

Active member
Re: Electric Water temp gauge help!

Shouldn't have to drill anything... There are water ports on the intake and both sides of the head. Might need a 3/8 npt to 1/8 adpater. That's about it
 

Gbodydriver

Member
Re: Electric Water temp gauge help!

If things were so easy on these trucks, everyone would have one :lol:. Nope get out your trusty "R" drill and 1/8" X 27 NPT tap and go at it. If you don't have a letter drill, you can use a 11/32" in place of an "R" drill. An "R" drill is .339" and a 11/32" drill is .34375"... There are some pics in this thread of an install.

Thanks thats a great help.. right down to the drill bit sizes.. damn truck gets on my nerves but Gotta love the forum...
 

BoostedSUV

Active member
Re: Electric Water temp gauge help!

Ok lost again... So your fittings just screwed in?

Should be 1/8 or 1/4 NPT pipe thread. You might need a reducer but there's an extra water port in front of the lower intake right under the thermostat housing. The sensor threads in and there's one wire that goes to the gauge
 
Top