Electrical Boost Gauge Reading ECU's 3 bar MAP?

SacDoug

Member
Is there such a thing as a boost guage that I can install and splice it into the ECU's MAP sensor for its reading? I want to know exactly how much boost the ECU is seeing and also I think it is just a cleaner install since there is no extra sensor and vacuum piping in the engine bay.

Also, I know the stock one is 2 bar but I will be upgrading to a 3 bar sensor so that is why I say 3 bar in the title.
 

Quickstop [UK]

Combating adversyty.
Re: Electrical Boost Gauge Reading ECU's 3 bar MAP?

MAP sensor takes its reading from the engine in the normal way. If you want to read the MAP sensor input then take a T off the input. The electrical output from the MAP would be a lot more tricky.

Taking the sensor from the MAP would increase the volume of system that the MAP reads, so would cause a decrease in response time and performance.

http://sytyarchives.com/howto/viewarticle.php?article_name=boost_gauge_fitting.php&dir=gauges

It's not really worth it. If you use an electrical sensor then that is a bit different and should not be too hard. You just need to install it inline the same system. That will not affect pressure much. I do not know too muc habout the electrical boost gauge side of things. Taking a circuit off the actual MAP sensor would be the best way.

3 Bar sensor etc would require an upgraded chip or for you to burn your ECM.
 

SacDoug

Member
Re: Electrical Boost Gauge Reading ECU's 3 bar MAP?

I should have been a little more clear. I want to electrically splice into a 3 bar MAP sensor. This will be after I upgrade my ECU and the map sensor.

What I am looking for is an electrical boost gauge that will accept the electrical signal from a 3 bar map sensor as its input.
 

James Thomas

"NO CLASS"
Re: Electrical Boost Gauge Reading ECU's 3 bar MAP?

I am not aware of a setup like this but I'm sure there is one some where that uses a transducer setup, maybe industrial type gauges?
______________________
James Thomas
 
Last edited:
Top