engine mounts

[Quickstop [UK]]

Got a weird question.

Am looking into a project and was wondering, how much of a difference would it make if you installed a plate underneath the engine mounts on just one side?

I am looking at installing a bracket under there on the one side. Of course both sides would be easy, just haing a blank on the other.

Basically, if there was a plate, say 3-5 mm under the mounts, how much of a difference would that make to the engine alignment/ trans alignment?

Would you need to change lots of stuff? Or could you get away with it?

 

[Quickstop [UK]]

Re: engine mounts

ttt.

Forgot to mention - RPM/ Moroso solid mounts are going on under the engine and the trans will be a 4L80E .

If I am right, the 3mm for the bracket will make little difference as the solids are lower than the stockers? The trans is on the polyurethane mount so the slight angle difference with the 3 mm elevation will be tolerable.

Can someone that knows something about this please chime in. If what I am planning on works, you will be very impressed! More importantly, it will be to the benefit of everyone :tup:

TIA,

Mark