engine rebuild?

[Neelsonwheels]

Hello
Iam the new owner of MightyTy.
The engine is getting rebuilt.
I will drop the truck off tomarrow morning.
The mechanic/machinist has done many GN's but never a Sy or Ty.
He is going to pull the motor disassemble the entire engine,clean,pressure test ,magnaflux,and blueprint every part.Then determine what the issue was then
replace what needs replacing. I am going to replace the oil pump with the suggested
Melling select,I am not sure what should be done while it is apart. I am open to suggestions.Thanks

 

[turboj91]

Re: engine rebuild?

you want a stock rebuild or more power?

btw, anyone notice that there is alot of engines being rebuilt lately? (more than the norm)

 

[midnightbluS10]

Re: engine rebuild?

There's a lot of engines being rebuilt all of the time.

Who's the builder?

 

[Neelsonwheels]

Re: engine rebuild?

The truck has plenty of power so I am not looking in that direction to much.
The previous owner has it pretty well setup.
The truck ran 11.3@118 with a 1.62 60 ft.
It has ENGINE
used built 4.3L
4 bolt main conversion w/ dipstick!
Waller Vortec head conversion
Port matched upper/lower intake
Comp 415 cam
ARP bolts
SRP pistons
Eagle rods
Carillo bushings
Fel-Pro SD head gaskets
my own custom a/c delete bracket
CVR Protorque starter

TURBO RELATED
Precision PT61mm turbo
3" ATR stainles downpipe
custom 4" Dynomax bullet muffler turndown
HKS SSQV blow off valve
RPM air to air intercooler conversion (under the bumper style)
Forced Inductions turbo blanket

TRANSMISSION
Prime Gears 4l80e conversion
Transformance built 4l80e
Yank PY3600 torque converter
B&M 28k transmission cooler
LOKAR 4l80 dipstick
serviced and quiet tranfer case

Chassis / Suspension
upgraded steering shaft
ZQ8 steering box
Hawk HP+ front pads
abs delete kit
new brake master cylinder
new brake booster
Billet Specialties Streetlite rims 15*10 around
275/50/15 Nitto drag radials around
lowered 2" with blocks in rear, turn torsion bar screws in front
front suspension down travel stops
rear suspension overload clamps (not currently installed)
KYB Monomax shocks

Electrical Performance
Big Stuff 3 engine and transmission control, 3 bar, DAI (push button data logging) & Wideband A/F
Greddy Profec B Spec 2 boost controller
Autometer electric full sweep fuel pressure gauge
Ramchargers dual fans
battery relocated to back in Moroso vented box
MSD 6A ignition box
GM HEI Blaster coil
NGK 4177 (TR-6) spark plugs

Fuel System
Kirban adjustable fuel pressure regulator
Snow Performance methanol boost progressive system
75# injectors
twin 255lph Walbro in tank fuel pumps
As for the rebuild I would like to get back together like it was previousley.
I was just wondering about the crank,gaskets,oil pump type stuff.
Thanks
neels