Engine wont start after washing!!!!

SYCLONE#1531

'MOFOFAST
My Sy wont crank after engine cleaning.(degreaser and water) It was runing excellent before the cleaning? Any suggestions appreciated!:roll:
 

Don W.

Stab it and steer it
Re: Engine wont start after washing!!!!

Won't even crank? Check bat connections. Remove, and re-install. Try a jumper bat. Does anything else wok? Lights? Radio? Check fusible links behind alt. Water may have shorted them.
 

SYCLONE#1531

'MOFOFAST
Re: Engine wont start after washing!!!!

The engine just turns over with no start. The battery is fine. Could water have gotten under the distributor cap?
 
B

BoostedGMC

Guest
Re: Engine wont start after washing!!!!

Bad spark plug boots?
 

bezerk

New member
Re: Engine wont start after washing!!!!

unwash it?

let it sit for a day and check back tomorrow.. might have dryed up.
 

Don W.

Stab it and steer it
Re: Engine wont start after washing!!!!

The engine just turns over with no start. The battery is fine. Could water have gotten under the distributor cap?

Yes, although somewhat doubtful. Pull it and give an air blast. If engine is warm let it sit for awhile see if it dries out whatever else might be wrong.
 

Syclone#2960

What ever it takes!!
Re: Engine wont start after washing!!!!

Fuel pump relay located on the driver side probably got wet. Do you hear the fuel pump charging up? I had a similar problem when I drove mine through a car wash. I had to hot wire the pump with a paper clip to make it home.
 

SYCLONE#1531

'MOFOFAST
Re: Engine wont start after washing!!!!

It cranked up after setting for 5 hours. It now has a ruff idle and stalls when I put it in gear? It usually will not crank back up after it stalls? I will pull the Dis cap tommorow and check for moisture. I also noticed that i had a small burn on the KB plug wire next to the downpipe. These plug wires have been on it since 93. Plug wires have about 15,000 miles on them with new acdelco 42ts plugs.(Plugs looked brand new) (58K on truck) I am still new to the Sy and very eager to learn everthing I need to know to keep it running and tuned! I guess I will order a set of taylor plug wires / MSD cap and rotor kit/ and MSD coil tommorow from Summit! Is it necesary to acces the passenger side plugs through the access panel? Any suggestions appreciated. :lol:
 
Last edited:

Don W.

Stab it and steer it
Re: Engine wont start after washing!!!!

Based on what you've said, moisture under the cap is the problem, plus that bad wire. You can prolly save your money on the coil. Get the cap, rotor, and wires here from Tucker Auto. (Vendors marketplace) Or another vendor here. And depending on the plugs age change them also while yur at it.
 

wildphil

I Love My Ty's
Re: Engine wont start after washing!!!!

Don is most likely correct. I have had this happen a time or two.
 

SYCLONE#1531

'MOFOFAST
Re: Engine wont start after washing!!!!

I pulled the cap and it was full of condensation!! I replaced it with a msd cap/rotor and it fired instantely up. It runs really smooth but has a slight rough idle. the previous owner installed a KB fuel preasure regulator. preasure I believe is at 50lbs idle? Could this cause the rough idle? The only mods are a open KB filter/ KB fuek pres reg/ air foil/ torque conv switch/ intercooler pump switch/ msd coil. my next mods will be custom chip/ methanol inj/ and pt54 turbo downpipe/ rpm exhaust/ fuel pump/ SYNAPSE BLOW OFF VALVE . I hope this will get me into the high 11s /low 12s. I will be installing everything at the same time. Any suggestions appreciated! :lol:
 
Last edited:
Top