English translation please....

Ty1642

Ty1642

Member
Re: English translation please....

E14 is the input for the stock (narrowband) O2 signal. If you are using a stock ECM or another ECM that is still looking for the narrowband signal, you need something wired up to this input.

If you are using the wideband for datalogging & monitoring (not control of fueling) then you can leave the stock O2 sensor installed and wired to E14. You will need another O2 bung in the exhaust to install the wideband sensor. The other choice is to replace the stock narrowband O2 sensor with the wideband sensor. In that case you need to wire E14 up from the wideband sensor so the ECM sees the signal it needs.

If your ECM only needs the wideband signal for fueling control, then you only need the wideband sensor, and don't need to wire up E14.
 
92TyLA

92TyLA

New member
Re: English translation please....

Ok so I was installing e14 and I broke one of the capasitors, any idea who sales them
 
You must log in or register to reply here.
Top