Exhaust /More or less restrictive?

tallcoolone

New member
Well, I just redid my exhaust. Took original exhaust mufflers and pipes off...then from cat back ran 2 1/2 in aluminized piping w/ total of three bends(compared to 4 bends w/ stock) ...used a warlock muffler and continued the 2 1/2 in piping to a 4 in oval tip by Ractive(sweet looking)...Since you can cap or uncap the warlock, I have tried both----kept it capped bec/ it killed my ears and resonated my Syclone to death;when its capped,it's quieter than stock and nice rumble.... Anyway, to make long story short, I recently read comparison of different exhausts(recent post) which included the Warlock.... Does anyone think my exhaust( setupwhich is incidentally not mandrel bent) which I intend to use capped is more or less restrictive than the stock system.... Any feedback appreciated.......
 

Syclonewillie

New member
I would have to say that it would be more restictive than your stock set up. The stock system hed duals coming off of the cat. I think if you were to get less restrictive you should have went with 3" from the cat back, it would be better than the 2.5".
let me try some thinking out loud :
ok you have a 2.5" pipe it has an area of 3.925"
if you have 3" pipe it has an area of 4.71"
So you would have over 3/4" oh area in the 3" pipe.
I would like to hear some comments on what I was thinking. Willie
 

damianhol

New member
Willie, his math, and I all agree. As long as everything is the same leading up to the differences (different pipes and muffler), the cross sectional area and inherent flow characteristics of the metal used are the only things to be considered. Granted, the 3 bends as opposed to 4 is an improvement, but not being mandrel bent will cause some disruption in the airflow passing through those bends. Go 3" or don't use pipes. We don't need back pressure for low end torque...that's why we have High stall torque converters that allow us to spool and launch.
 
Top