FAST refresher...

protosy

New member
Re: FAST refresher...

4C FED said:
...

So, I need to disconnect the tan wire, crank the motor & set the timing to 6 degrees BTDC?

Thanks

that is exactly what I did. I have an adjustable light that allowed me to dial in 6 degrees on the light then i set the mark at 0 on the balancer. then set 6 in the FAST program as your crank reference angle and you are good to go.

chad
 
Even easier way.... just turn on the dashboard with advance degrees being shown. Set the timing light to whatever FAST thinks it's running, probably around 30 degrees at idle. You should have your 0 mark on your balancer line up with your 0 mark on your pointer when the timing light says what FAST is requiring. That's the easiest way with no disconnecting of the tan wire. You can set your crank reference angle to whatever number you want this way. I normally set it to 10.
 

protosy

New member
Christian Dionne said:
Even easier way.... just turn on the dashboard with advance degrees being shown. Set the timing light to whatever FAST thinks it's running, probably around 30 degrees at idle. You should have your 0 mark on your balancer line up with your 0 mark on your pointer when the timing light says what FAST is requiring. That's the easiest way with no disconnecting of the tan wire. You can set your crank reference angle to whatever number you want this way. I normally set it to 10.

that is precise ly what i did to verify that i had it all timed dead nuts.

chad
 
Top