First time on datamaster.

Backzilla

New member
Im hoping ive podted in the right bit. I hood the ty up to datamaster today for the first time and i thought i would try and us your guys expert advice. Is this normal ?

firstrun.jpg
 

Backzilla

New member
Re: First time on datamaster.

Right ive look though the data again and pick the peak of the graph as appose to the top speed. here goes.

firstrunmk2.jpg
 

WyoSyclone

Active member
Re: First time on datamaster.

Im hoping ive podted in the right bit. I hood the ty up to datamaster today for the first time and i thought i would try and us your guys expert advice. Is this normal ?

firstrun.jpg


On this one, you shouldn't have 1.2 degrees of KR with 0% TPS... that's a little strange.


Right ive look though the data again and pick the peak of the graph as appose to the top speed. here goes.

firstrunmk2.jpg


On this one, I assume your were going for a wide open throttle (WOT) run.... TPS is at 92.5%.... if you were going for WOT, I'd check to see why you weren't getting 100%. Injector DC is a little high.... RPM is a little low for a WOT shift... should be up around 4350.

If you notice, your values down beside the graph are different than what is shown above in the cells. If you move your cursor anywhere across the graph while you're doing your screen capture it will change the readings at the side of the graph to whatever your cursor ran across last... I just make sure I avoid the graph when I'm doing a screen capture.

Double click the DTC ERROR box and see which code you're throwing..
 
Top