Flashing check engine while driving.

TurboJunk

questionable
As im driving the truck seems to loose power for a second then regain it. as this happens the check engine light blinks. it happens mostly when trying to going into boost (giving it WOT). now my thought are that maybe the computers loosing power or ground.

If im correct the computer gets power from the two wires that go to the 2 screws on the firewall by the AC box..... and 2 wires go to the fuse box. and grounds from the 2 wires that are usually boltsed to the back of the drivers side cylinder head. Since my batteries in the back i have a wire that goes from the battery wire on the starter to that junction block on the firewall, for power.

this started to really hapenn friday evening when i pulled over to reset the computer by pulling the ECMb fuse out. after that it has been going crazy.

what makes me think the computer is temporary loosing power/ground is there will be a code coming up , then it will happen and when i go to check the code theres nothing in code history.

Anyone have any thought on my dilema....
 

berzerker

wookie
Re: Flashing check engine while driving.

i think your on the right track with power supply to ecm. most bad ground problems will cause a flury of logged codes , or a shitty running engine all together
 

Robert Lone

MUTANT
Re: Flashing check engine while driving.

I had this poblem w/ my brother's 92 Camaro. Someone had put a code key in the diagnostic port and left it in there. Just a thought...
 

the baPhoon

Active member
Re: Flashing check engine while driving.

Dude after i got my truck running tonight it did the same damn thing. To the T man loss of power flashing check engine, then it just straightened out and drove normal.
 

turbodog

Donating Member
Re: Flashing check engine while driving.

Flashing 'check engine' light means the ECU is in 'limp home' mode. It means the computer is not getting the inputs needed to calculate fueling at all, so it's running default values intended to keep the engine running (barely).
 

TurboJunk

questionable
Re: Flashing check engine while driving.

yeah.... it flashes quick when the truck is buggin out. it just dies then regains it self, the tach flutters and some times it will back fire (a flame like you wouldnt believe). Im going to go over the power/ground wires to the ECU today. thanks guys
 

TurboJunk

questionable
Re: Flashing check engine while driving.

Added 2 more ground wires today. one from the firewall to the intake and one from the chassis to the block. i thought everything was ok, but then realized it does it more when its hot.

it still does it and theres still no codes.... could it be somehting in the fuse box? or in the dash board wiring harness to the computer.

im lost

can anyone tell me all the wires that go to the computer. i know theres 2 under the hood that go to the junction block, 2 from the fuse box (the ecm and ecmb fuse) and 2 or 3 ground wires that bolt to the back the head.
 

wantingasy

Active member
Re: Flashing check engine while driving.

Are you running the stock 2 bar MAP and chip? You could be getting boost creep and the ECM shuts you down over 14.7.... Happened to me a couple of times and I had the same symptoms and the CEL came on for about 10 seconds then went off.
 

TurboJunk

questionable
Re: Flashing check engine while driving.

wantingasy said:
Are you running the stock 2 bar MAP and chip? You could be getting boost creep and the ECM shuts you down over 14.7.... Happened to me a couple of times and I had the same symptoms and the CEL came on for about 10 seconds then went off.
im running a stock chip and 2 bar. but im also running only 12 psi of boost. theres no boost controller with the vaccum stright to the wastegate its only gettin 12 no over boost, i thought that in the beginning.

the problems only seem to happen when the trucks hot.
i have another computer im going to try and swap then and see if it changes anything. Maybe i messed something up when i pulled the fuse out to reset the computer... its a long shot but anything is possible
 

Turbo Junky

New member
Re: Flashing check engine while driving.

You are misfiring. I have seen this before on other trucks. It will lose power almost like you are running on 4 or 5 cylinders. As soon as you let off it will stop misfiring and run like normal.

Do me favor and make it happen and stay laid into the throttle and see if it ever stops bogging out. Then let off and the misfiring will stop and your CE light will start flashing.
 

TurboJunk

questionable
Re: Flashing check engine while driving.

Turbo Junky said:
You are misfiring. I have seen this before on other trucks. It will lose power almost like you are running on 4 or 5 cylinders. As soon as you let off it will stop misfiring and run like normal.

Do me favor and make it happen and stay laid into the throttle and see if it ever stops bogging out. Then let off and the misfiring will stop and your CE light will start flashing.
it would only happen if i was on the gas. it seems to stopped for now i went over the wiring and did a tune up i changed a few other things and got the truck to stop missing

ill repost if it comes back
 
Top