fuel pressure all over !?!?!

flintdawg

New member
i upgraded my fuel pump to the walbro 255, changed my fuel filter and i put in a dequick afpr and now my truck wont hold a steady pressure its all over and its shooting codes like there's now tomorrow, we have bled the lines twice and had air in both times.....anybody know how to fix my issue? also base press. should be at like 42 psi right? thanks in advance


_________________
Mike Flint
'92 Typhoon
Red/Red
"Nappin"

<font size=-1>[ This Message was edited by: flintdawg on 2002-03-05 10:22 ]</font>
 

ronniejoe80

Member
Better check the pump installation. Sounds like its sucking air, and that can only happen in the tank. Fill the tank all the way and if it eliminates it, then you will know for sure. But, you will have a full tank of fuel to deal with when you pull it back apart.
 

jwaller

Evil Genius/SyTy Guru
yep....sounds like a bad installation....there is absolutly no reason to drain the air...it automatically does this as soon as you turn the pump on BC it drains excess fuel/air back to the tank.(thats how it mantains the set pressure)..you have left off a clamp or something
 

flintdawg

New member
it now has a full tank of gas and isnt sucking air but it still doesnt hold a constant fp....its set at 42psi and it will vary 5psi either way....could it be that my electric fp guage sending unit is mounted inline with my afpr? should i mount my guage off of the bleeder valve?
 

V6 Kompressor

New member
If you are talking about holding a steady pressure while it is running, most engines don't, but if you have the fuel pump relay energized, engine off, the pressure should be steady. You may have a return line restriction or something....If you are talking about when it is running, hook up a vacuum gauge, and see if it too is fluctuating, check for vacuum leaks ect... and what codes are you getting...map sensor codes, O2 codes, numbers ect?????
 

Pittman

New member
Mine did the same thing! After the install I checked the fuel pressure and the needle was oscilating so bad it was a blur. The truck was still driveable with the 5lb oscillation. I though it was becuase I took the pulsator out or something. Anyway, after a day I checked it again and it was as solid rock. I'm not saying this would be the case with yours but I was overjoyed that I didnt have to yank the bed off again!
 

Pittman

New member
I forgot to ask. Im thinking about getting the autometer electric fuel gauge. How does it hook up anything else you have to buy? I suppose it just has a sending unit hooked up to the fuel rail somehow
 

jwaller

Evil Genius/SyTy Guru
some ppl like to "T" into the pressure side of the supply line; some ppl like to use the schrader valve...but the schrader valve was never meant to have a pressure sender hanging off of it for a prolonged period...I like the T method BC you can hide all the junk under the truck instead of adding more clutter to the engine bay
 

flintdawg

New member
i am relocating my fp sending unit to the schrader valve...i am using stainless steel relocation kit so the sender doesnt hang off the fuel rail...we'll see what happens i will keep you posted....and i will see what the exact codes are...thanks again

_________________
Mike Flint
'92 Typhoon
Red/Red
"Nappin"

<font size=-1>[ This Message was edited by: flintdawg on 2002-03-06 12:48 ]</font>
 
Top