fuel pressure jumping around

5678TA

New member
Hey guys,
so I just recently got my fuel pressure gauge working and my fuel pressure is jumping between 20-60 psi when its warm. Cold, it stays around 33-38 but still fluctuates. Is my pump going bad? Also, do I NEED an afpr if I get a walbro 255?
 

Don W.

Stab it and steer it
Re: fuel pressure jumping around

Yes and Yes.

But before you go there do this: Motor off, turn key on. Fuel pressure should go to the set point and hold there (fuel pump runs for 2 secs when you turn the key on.) Once pump stops FP should hold. if it drops you have problems.

Potential problems here are:

Bad regulator. (Walbro not necessary just to replace regulator.)
Bad fuel pump. Here it gets dicey. Is it the Fp itself or the pulse damper above the pump but still in the tank or?
Leaky injector.

Bad line somewhere. Any leaks? Have you inspected all the hoses?

And a shot in the dark: Did you remove the schrader valve in the fuel rail where you connected the gauge?
 

5678TA

New member
Re: fuel pressure jumping around

Alright so I checked pressure with motor off and it held fine. I just bought a regulator from renegadepete so ill throw that on and see what happens.

I'll do a visual check after work. And yes I removed the valve when doing the gauge.
 

5678TA

New member
Re: fuel pressure jumping around

damn....

so visual is good, changed regulator for Accufab unit and pressure is still jumping around!!!!:rant:

next is fuel pump.
 

5678TA

New member
Re: fuel pressure jumping around

The gauge rapidly fluctuates and it worked fine when I got it. Held steady and rose with boost. Now it wont stay still. guess i'll give AEM a call on Monday.

Btw, gauge is AEM and regulator is accufab(as of today, stock beforehand)
 
Last edited:

It's just a six

Super Member
Re: fuel pressure jumping around

When I hook up an external fuel pressure gage to the fuel rail,,, the needle will jump all over, say 40-50 psi & cannot really get an accurate reading,,, that's if I purge the line of air to the pressure gauge.

If I just hook up my external pressure gauge & not purge the line of the air that is in it,,, that dampens the needle & I can get an accurate read w/out the needle jumping very rapidly.

So in short, a gauge needs some type of dampening device either air in the system, a small fixed orifice , or a liguid filled gauge.
:2cents:

What is that rubber part (near fuel pump) that dampens also,, the pulsator?
 
Re: fuel pressure jumping around

Im going with the pulse dampener or if its an electrical FP gauge with isolator that is the culprit.
 

5678TA

New member
Re: fuel pressure jumping around

another thing i forgot to mention was that when i'm cruising and suddenly let off the throttle, pressure goes steady for a few seconds.
 

5678TA

New member
Re: fuel pressure jumping around

well that is good news and bad news. good news is no need for fuel pump work. bad is the stainless sensor that comes with the gauge kit is like $155. F me, i think i'll go with the alternative $70 brass sensor.

is an accuracy of +/- 0.5% worth the $155 over +/- 3% for less than half price?? I am having a difficult time justifying to pay over 3/4 of a complete gauge kit, just for a sensor.

and for those of you who will say go autometer, i like my stuff to be a matched set and since i'm running a tru-boost, i'm not going away from AEM till at least another two sensors crap out. why two more? i give most everything a three strike chance.
 
Top