fuel question

vettandtyphoon

New member
hey guys.

with a set of 60 lb injectors and high flo rpm fuel rails, i also have the rpm double pumper dual 255 in tank pumps.

what should base fp be set at with the vacuum line disconnected?

p.s do you guys change this according to weather?

got one more question

have you guys ever ran into this. the truck would start and run just fine. i pulled into my sisters driveway let it idle for a minute. then it died out. wouldnt start. i had to floor the truck and start it at the same time and it fired up. rev'd it up a few times and it idle's fine!!
 
Re: fuel question

when you put the pedal to the floor and then crank the motor it is in clear flood mode and doesnt inject fuel when cranking. i think. What is your fuel pressure set at and what is the 02 sensor reading at idle?
 

vettandtyphoon

New member
Re: fuel question

i currently don't have a datamaster to hook up to it or anything. i will on wensday,

fuel pressure is currently at 50 psi with the line detached, and like i said dual intake pumps and 60 lb injectors
 

Ty 1885

Member
Re: fuel question

Sound like its running rich at idle. Lower fp to 43psi with line off, see if it runs better.
 

vettandtyphoon

New member
Re: fuel question

Sound like its running rich at idle. Lower fp to 43psi with line off, see if it runs better.

that did the trick for the idle. i kinda figured that because i raised the fp a few weeks ago when i went to the track. Now, it needs more fuel when in it.... is that all in the tune? we are going out wensday to dial her in. so base fuel pressure should be about 43-45? at idle line detached.
 

TYTILIDIE

METH HEAD
Re: fuel question

Yes it is all in the tune. I wouldn't do any mods with out datamaster and or some real tuning capabilities.
 

vettandtyphoon

New member
Re: fuel question

Yes it is all in the tune. I wouldn't do any mods with out datamaster and or some real tuning capabilities.

the truck is fully built already..lol built motor, big turbo, a2a intercooler, dual intank pump setup 60lb injectors, carb style intake with elbow, built trans etc...

i'm going to get it all tuned in tomorrow at the track hopefully!!!
 
Top