GM coil vs. MSD coil

HighPerformanceTrucks

Lift & Shift Specialist
I'm thinking my motor cutting out problem may be attributed to a tired MSD coil.

Anyone know if the MSD coil is worth replacing or should I go back to a GM coil?

I haven't had the best luck with MSD products.

Adam
 

Captain Morgan

Moderated User
I run the MSD GM replacement coil #8226. I had a cutout problem at WOT when i first got my truck too, I changed everything at once, problem was solved. I later went back and swapped the stock one back in and didnt see any change, so I pulled it and just kept it for a spare untill the truck was stolen last year. Now I just have the MSD one. I havent had any problems, but havent seen any gains either.
 

Tommyquest

The Member's Member
I like the red color. It's pretty. But seriously, I haven't noticed any difference. Maybe at high boost pressures it would be beneficial.
 

Loeryder

New member
If anything the hotter coil is harder on the cap n rotor.

Check your center post and other contacts.
 

BigAl...

Member
I had a similar problem last year and it turned out to be the p/u coil.

HTH
BigAl...

P.S. it was easier to swap the whole dist.
 

Falco

Donating Member
I'm also using the MSD coil, no improvement over stock. But it's not that expensive and I also like the color. :wink: So far so good...

Later,
 

ghettosled

SYTY SUPERSTORE
i want to say the msd coil is even weaker then the stock coil, but i'm not 100% sure as I looked into it awhile ago. Its been referred to as a stock coil painted red on more then one occation.
 

Captain Morgan

Moderated User
ghettosled said:
i want to say the msd coil is even weaker then the stock coil, but i'm not 100% sure as I looked into it awhile ago. Its been referred to as a stock coil painted red on more then one occation.
except its not paint :)
 
Top