having a new problem burning a chip

turbotater

New member
i am using a moates adapter and cats programming
software . i have used it for over two years now on my
92 firebird and now i am using it n my 'phoon
i burned a modified atr bin i was using with good
success the stock engine , i now have ported vortec's
and a cam , i started by adding fuel in the accel enrichment
vs map and tps tables to get rid of a hesitation on throttle opening
after a couple of successful burns now all i have is a check
engine light and the truck runs like i have no chip in it .
i am using amd 29c256 chip i verify it is blank and then
try to burn the original program still no luck
any ideas

mike
 

kwick6

Donating Member
Re: having a new problem burning a chip

turbotater said:
i am using a moates adapter and cats programming
software . i have used it for over two years now on my
92 firebird and now i am using it n my 'phoon
i burned a modified atr bin i was using with good
success the stock engine , i now have ported vortec's
and a cam , i started by adding fuel in the accel enrichment
vs map and tps tables to get rid of a hesitation on throttle opening
after a couple of successful burns now all i have is a check
engine light and the truck runs like i have no chip in it .
i am using amd 29c256 chip i verify it is blank and then
try to burn the original program still no luck
any ideas

mike

which moates do you have? Is the chip facing the correct way in the socket?

Here is a pic of mine. You may have a smaller socket, but the chip should still face the same way.

http://huryde.server277.com/Gallery/Mods/DSCN1092
 

Sy769

Donating Member
Being a 256 chip you are doubling the original bin or setting the offset?

You probably are just all I could think of.

After you burn it can you read it and compare the data to the original bin?
 

turbotater

New member
after some digging i think the problem is the voltage the
chips switches at , this one is 5v and i think it is supposed
to be 12.5 v so i probably fried the chip due to increased
amperage .
no i could not read it
i have some old 27 128 chips i am going to get an eraser today
and see if i can use them

what chip number are you guys using ?

mike
 
Top