BigAl...
Member
As some of you know I installed speedpro on my truck last week(Big thanks to Nolan), idle, off idle and drivability are just plain awsome. Well I'm having trouble diagnosing a really bad stumble. If I slowly take the revs up to 2200-2500rpm and then step on it, it feels like I hit a rev limiter, BUT if I slowly raise them to over 3000rpm and then step on it, it runs like a raped ape but when it shifts it does it again. I've changed the cap/rotor, ignition module, tightened the gap to .025. Plugs look great. this is driving me nuts. I really feel like it's a hardware problem not a calibration problem. The a/f ratio's are around low 11's when this is happening. any suggestions would be greatly appreciated
TIA
BigAl...
TIA
BigAl...